Vari Lite Virtuoso DX User Manual download pdf (Page 259)

ADVANCED EFFECTS FEATURES : EFFECT TIMING

02.9651.0001 C 23-Sep-02 233

• Duration - (set using window only) either an overall duration "Time" or "Cycle"

count. These values can be set in the Effects window with the restriction that an

effect can have one or other, but not both. Definitions for Time and Cycles are as

follows:

Time - length of time an effect will run before initiating the Fade Out time. At

this point, the intensity will fade out in the time specified. (In this case, only

effects which have intensity included, will respond to this value. In addition, if

another submaster has intensity for those channels, Highest Takes Precedence

rules apply. Refer to “HTP (Highest Takes Precedence)” on page 254.)

Cycles - specifies how many times the set runs through the sequence. After

running the specified number of times, the effect will stop and await manual

restarting or go to the next event.

• Step Time - (set using encoder only) the time between activation of a sequence

step and the next sequential step. On an effects level, Step Time can be used in

two ways: either to set all sequence steps to the same timing value or to scale the

timing values of sequence steps (when sequence steps have different timing values

already stored). Step times can also be set individually from the Sequence Editing

mode (refer to “Sequence Level Timing” on page 235) or scaled by turning the

encoder. The step time shown is that of the last step. The "all" indicator is to show

that all step times will change.

Assigning Effects Level Timing

Timing can be assigned and modified using the encoders, command-line keypad or the

Effects window.

From Select Displays

Assign overall Step, Fade In, Fade Out or Wave

timing:

Step 1. At Effects Control, press [Effects].

Step 2. At Effects select display, press [Effect

Select Button] of effect you wish to modify.

Step 3. Using encoders, set times as required. (To

set all step times to same value, turn

encoder to 0.00 and then up to required

value. Otherwise values will be scaled.)

Step 4. Press [Store] / [Effect Select Button] to store changes.

Note: The "all" indicator is to show that all step times will change.

all

step

0.18

FadeIn

4.30

FadeOut

4.23

wave

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 400 401

Comments to this Manuals

No comments

Vari Lite Virtuoso DX User Manual Page 259

Comments to this Manuals

Related products and manuals for Sport watches Vari Lite Virtuoso DX