VARI❋LITE® - VIRTUOSO™ / VIRTUOSO™ DX CONSOLE USER’S MANUAL
220 23-Sep-02 02.9651.0001 C
Store, Update, and Selective Store with Submasters
After a cue has been loaded and played back in submaster, its channels can be
modified and re-stored using standard cue store commands.
For more information, refer to “Update” on page 216 and “Selective Store” on
page 217.
Modify a cue in a submaster:
Step 1. Run cue in submaster.
Step 2. Using manual control, modify parameters as required.
Step 3. Press [Update]* / [Choose].
* [Store] or [Sel Store] can be used instead of [Update].
Unexpected Behavior
When a cue is re-stored while active in a submaster, unexpected behavior can occur if
any selected submaster’s fader is set below full. This happens as a result of two
factors. First, when the intensity is stored at a lower level as a result of a fader, then
the updated cue is automatically loaded back into the submaster, it will immediately be
affected (for the second time) by the fader setting causing a further reduction in
intensity output. Second, if more than one submaster is selected, the Highest Takes
Precedence (HTP) protocol must be considered. If a cue, active in the first submaster,
is updated to an intensity level below that of the second submaster, then after the cue is
automatically reloaded to the submaster, it will be overridden by the higher value of
the second submaster (which now controls the intensity output as a result).
Comments to this Manuals